Amsamotion Usb-cn226 Driver Download //top\\ -

High-speed isolated versions protect both the PC and PLC from electrical noise and voltage spikes common in factory environments.

programming cable, you must install the proper driver to simulate a COM port for communication with Omron PLCs. Official Driver Downloads

Open a terminal (or serial tool like Putty/Tera Term) and try to open the COM port. No error means the driver is working.

Ensure the RS232 circular connector pin is securely fastened to the PLC port and check for bent pins.

Note: If you see a yellow exclamation mark next to the device, the driver did not install correctly. Proceed to the troubleshooting section below. Step 3: Configuring CX-Programmer for the USB-CN226

Over the years, Amsamotion has manufactured the USB-CN226 using two different chipsets:

The cable simulates a traditional serial (COM) port on your computer, enabling programming software like CX-Programmer to communicate with the PLC as if it were connected via a legacy RS232 port. There is an important compatibility note, however: it is not suitable for the , which uses a different, standard square USB-B port like a printer. For those models, a different download cable is required.

Follow these steps to properly install the driver on a Windows environment. Do not plug the cable into your computer until instructed. Phase 1: Preparation

Select Browse my computer for driver software . Navigate to the folder where you extracted the driver files in the previous section and select it.

Lower-cost variants frequently use the CH340 chip. Drivers for this can be found on sites like PLC ONE .