Edmi Mk6n Genius User Manual

The meter uses a standard terminal configuration for direct connect or transformer operated (CT/VT) connections.

Beyond standard energy metering, the Mk6N’s true power lies in its advanced analysis and customization capabilities.

The terminal block layouts vary based on whether the unit is a direct-connect or a CT/VT operated meter. Always refer to the specific wiring diagram printed on the inside of the meter's terminal cover. edmi mk6n genius user manual

For additional support and resources, users can visit the EDMI website, which provides a range of technical documentation, datasheets, and user manuals. Users can also contact EDMI's customer support team for assistance with any questions or issues they may have.

The EDMI Mk6N contains electronic circuit boards, a liquid crystal display, and a lithium battery. Do not dispose of the meter with standard commercial waste. Follow local environmental regulations regarding the recycling of electrical and electronic equipment (WEEE). The meter uses a standard terminal configuration for

| Issue | Likely Cause | Action | |---------------------------|---------------------------------------|--------------------------------------| | Blank display | No power or meter damaged | Check supply voltage to meter | | No pulse output | Wiring error or pulse output disabled | Verify terminals; check configuration| | Wrong tariff reading | Incorrect TOB (Time of Binding) setup | Reprogram tariff table (technician) | | Optical reading fails | Wrong baud rate or protocol mismatch | Set to 9600 bps, 7E1 or 8N1 as needed|

Includes an ANSI Type 2 or IEC 62056-21 optical port, RS-232, and RS-485 (multi-drop). It also supports internal modem options for GPRS/GSM and protocols like Modbus and DNP3. Always refer to the specific wiring diagram printed

57.7V to 240V (Phase-to-Neutral), 3-phase 4-wire or 3-phase 3-wire

The MK6N is AMI-ready, supporting various remote and local communication protocols.

A: Power off. Press and hold the X and Y keys simultaneously, then power on. The screen will ask "Reset all settings?" Press ENTER.