Are you replacing an or starting a brand new installation ? Share public link
Install a bypass valve set. This allows you to switch back to hard water for garden taps or maintenance without disconnecting the unit. Connect the Lines:
Plan enough clearance above the unit to load block salt comfortably through the top cover.
Load two blocks of Harvey water softener salt into the front compartment. 🔍 Troubleshooting Common Installation Mistakes Potential Cause Action Plan Hoses are kinked or valves are partially closed. harvey hv3 water softener installation manual
Open the bypass valve and run a cold tap to clear any debris or air from the pipes.
Connect the from your main water supply to the port marked "IN" on the back of the Harvey HV3.
Keeps hard water flowing to the house when the softener is turned off or disconnected. 🛠️ Step-by-Step Installation Instructions Are you replacing an or starting a brand new installation
Do you have a ?
Select a flat, level surface capable of supporting the unit when filled with water and salt (approximately 40-50 kg).
Pipe cutters, adjustable wrenches, and silicone grease (for plumbing O-rings) 📐 The Harvey HV3 Plumbing Diagram & Bypass Configuration Connect the Lines: Plan enough clearance above the
Open the softener slowly to allow water into the first cylinder.
Disclaimer: This article provides general information. Always refer to the official, up-to-date Harvey installation manual provided with your unit.
