Mitsubishi Vfgl | Manual
| Model Series | Capacity (kg) | Speed (m/s) | Application / Notes | | :------------------- | :------------------------------------- | :---------------------------- | :-------------------------------------------------------------- | | | 450 - 1350 (4-18 persons) | 1.0, 1.5, 1.75 | Microprocessor control for speeds ≤1.75 m/s. | | MAXIEZ-LZ | 320 - 2500 (4-33 persons) | 1.0 to 2.5 | Machine-room-less (MRL) model. | | MAXIEZ-CZ (B) | 630 - 2000 (8-26 persons) | 1.0 to 4.0 | Small machine room; B variant is for hospital beds. | | ELENESSA | Varies by configuration | Typically MRL low to mid-rise | VFGL/VFGLC controller for commercial/residential buildings. |
The VFGL series represents an era of Mitsubishi Electric innovation where they pioneered control for gearless elevators. These manuals are highly sought after by elevator enthusiasts and technicians on platforms like Elevator Wiki and specialized forums because they bridge the gap between old-school heavy machinery and modern electronic control.
Verify brake fluid reservoir levels and test parking brake engagement. Drain water separators (on diesel models). Every 250 Hours (Monthly) Change engine oil and replace the oil filter. Clean or replace the primary air cleaner element. mitsubishi vfgl manual
: A phase-failure safety indicator. If any primary electrical supply phase drops, this light turns off immediately. Load Weighing Calibration Procedures
: Use MON1=1 and MON0=0 for real-time faults. Adjustments : | Model Series | Capacity (kg) | Speed
The you are trying to complete right now?
Available in both parallel (8-bit) and synchronous serial interfaces. Pinout Configuration and Hardware Interfacing | | ELENESSA | Varies by configuration |
Check transmission fluid levels and replace the transmission filter. Troubleshooting Common VFGL Issues Using the Manual
| Speed (m/s) | Activation Position [mm] (±15mm) | Switch Set Installed | Notes | | :---------- | :----------------------------------------------- | :------------------- | :----------------------------------------------------- | | | USR/DSR = 1450 | 2 sets | Standard configuration. | | 1.6 | USR/DSR = 2400, IUSD/IDSD = 3400 | 2 sets | For speeds ≤1.75 m/s, UL/DL is disabled. | | 2.0 | USR/DSR = 4050 (3550 for high acceleration) | 3 sets | For speeds ≥2.0 m/s, includes an extra USR/DSR. | | 2.5 | USR/DSR = 4700, IUSD/IDSD = 7050 | 3 sets | Virtual UL/DL function required. |