Narishige Pc10 Manual New ^new^ -

Disconnect the power. Loosen the terminal screws holding the filament legs. Remove the old coil, insert the new Narishige factory-approved platinum filament, center it visually around a test capillary, and firmly tighten the screws. 7. Troubleshooting Guide Probable Cause Corrective Action Glass does not separate Heater settings are too low.

: Some experts suggest it is best suited for users who already understand pipette pulling mechanics due to the adjustment time required. narishige pc10 manual new

Turn off power. Inspect the coil for breaks. Tighten holding screws. Overheating or uneven cooling air. Disconnect the power

Labs that need consistent, simple puller for standard patch pipettes (1–5 MΩ) without complex programming. Excellent for teaching labs or routine recordings. Turn off power

Secure the top end of the glass tube into the upper clamp first. Ensure it is perfectly vertical.

Manually lift the upper and lower sliders to ensure smooth, unhindered vertical travel. 3. Description of Controls and Indicators

Though the PC-10 has passed the torch to the PC-100, it remains a capable and respected instrument in labs where it is still in service. By leveraging these digital strategies, you can ensure its continued, safe operation for years to come. The preservation and sharing of this documentation are a testament to the resourcefulness of the scientific community, ensuring that valuable tools remain useful long after their original support lifecycle has ended.