The way to obtain this HSP is through the Siemens Industry Online Support (SIOS) portal. Follow these steps to locate the official source:
: For newer TIA Portal versions (V16 and above), the TIA Administrator tool can automatically download and install required updates and HSPs.
: HSP stands for "High Speed Performance," and SP10 likely refers to a specific service pack or patch level for that version. siemensmcdrivesv15 hsp47sp10 download exclusive
| Q | A | |---|---| | Do I need a special cable for the USB update? | No – any standard (or USB‑C, depending on the drive’s service port) works, provided the stick is formatted FAT32. | | Can I install HSP47 SP10 on a non‑SMC‑licensed drive? | No. The firmware package is cryptographically signed and will refuse installation on a drive lacking a valid SMC licence key. | | Will my existing PLC program need changes? | In most cases no – the drive presents the same PDO/IO mapping. Only if you decide to use the new Eco‑Mode or Adaptive FOC , you may need to add a few parameter writes in the PLC. | | What is the expected downtime for an OTA update? | Approximately 60 seconds (firmware flash) + 30 seconds for verification – the drive remains in Safe‑Stop mode during the process. | | Is the OTA channel protected? | Yes. Siemens Cloud uses TLS‑1.3 , mutual authentication with device certificates, and firmware payload is signed with an RSA‑4096 signature. |
Attention Automation Engineers and TIA Portal users! 🛠️ The way to obtain this HSP is through
The list populated. Most were SP1, SP2, up to SP9. Then, at the bottom, grayed out but present, sat the file: .
Ensure that is fully installed on your system. | Q | A | |---|---| | Do
Select the option labeled .
The HSP47SP10 is a Support Package for . Its primary purpose is to allow engineers to configure SINAMICS drives that use firmware version 4.7 SP10 .
The exact text string represents a critical Hardware Support Package (HSP) container required by Siemens TIA Portal V15 and SINAMICS Startdrive V15
