Cycle through the menu until you locate the (Auto-Tuning) parameter. Change the AT value from 0 (Off) to 1 (On). Press and hold SET to exit back to the main display.
Indicates electrical noise interference or a failing sensor shield. Route sensor cables away from high-voltage motor power lines.
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
Websites that host user manuals can be valuable resources. xmtg-2000 temperature controller manual pdf
Used to enter parameter menus, switch between parameters, and confirm settings.
The or OUT light on the front panel will begin flashing consistently, indicating that auto-tuning has commenced.
To optimize the controller for your specific thermal system, initiate the auto-tuning (AT) function. The controller will then cycle the heating on and off several times to learn the system's characteristics. Once complete, it will automatically calculate and store optimal PID values, ensuring precise control. Cycle through the menu until you locate the
Safety and process protection are enhanced by two configurable alarms. These can be set to trigger if the temperature goes above or below a defined threshold, alerting operators or triggering a shutdown to prevent equipment damage or product spoilage. Note that due to its compact size, the XMTG-2000 typically supports only one or two alarm outputs.
Connect the positive (+) wire to Terminal 9 and the negative (-) wire to Terminal 10 . Leave Terminal 8 empty.
The controller is designed for industrial environments. It operates on a wide range of AC voltages (e.g., 85-242VAC, 50/60Hz) and has low power consumption (typically under 4W). It is rated for ambient temperatures of 0 to 50°C and non-condensing humidity below 85%. Indicates electrical noise interference or a failing sensor
The XMTG-2000 features a built-in auto-tuning algorithm. This function automatically calculates the optimal Proportional (P), Integral (I), and Derivative (D) settings for your specific heating environment.
The XMTG-2000 is not a "plug-and-play" device out of the box. It requires manual configuration of:
If your unit has an blinking, it is auto-tuning. Do not interrupt this process (takes 10-30 minutes).